Hi Guys, just about to order parts for my 1st quad build and just looking some advise on what im...

[G+_Oliver Burges]

Hi Guys,

just about to order parts for my 1st quad build and just looking some advise on what im ordering is sufficient, or is there something i can swap out?

 

Thanks in advance Oliver

 

Product List:

*New Naze32 quad Controller 6DOF for Acro AfroFlight

 

*CC3D Flight Controller Power Distribution Board LED FPV Control for QAV250

 

*High Quality New 4X 6045 6*4.5 Carbon Fiber Propeller Prop CW/CCW for QAV250 

 

*Turnigy nano-tech 1500mah 3S 35-70C Lipo Pack 250

 

*Flysky FS-T6 2.4GHz 6CH Mode 2 Transmitter W/Receiver R6-B

 

*4 pieces X2204S 2300KV Brushless Motor

 

*4X Emax 12A Speed Controller ESC with SimonK Firmware

 

*3K CF Carbon Fiber QAV250 4-Axis 250

[G+_Taylor Graham]

Are you buying a legitimate QAV250? You wont be able to fly 6x4.5 props on the actual qav250 without the motor mount extensions. You might want to look into different ESCs too. Like the SN20a's. A lot of really tiny escs have come out recently. You're going to be pulling 20+ amps with those motors and 6x4.5 props. You can get away with 12a escs, but you might want to look into something else.

[G+_Oliver Burges]

Thanks Taylor

[G+_Joshua Delaughter]

You should only need one flight controller (Naze32 OR CC3D), or did I misinterpret?

[G+_Oliver Burges]

Hi Joshua,

 

the CC3D item is just the power distribution . . .  i think!

[G+_Joshua Delaughter]

Ah, as in its a PDB for a CC3D? CC3D is definitely a flight controller

[G+_Oliver Burges]

yeah i had the CC3D as my flight controller an switched to the NAZE i just think the power distribution board is called that.....i would presume it work ok

[G+_Taylor Graham]

Just check the hole spacing, im not sure if its the same. Naze is 30.5mm between holes i think. You just want to make sure you can mount it to your frame.

Another good PDB has the same spacing as the naze is the AfroPDB. Its basic, no LC filter/voltage reg, but it works.

[G+_Oliver Burges]

Thanks Taylor I'll look into it, not something I thought about but definitely something I need to consider