Jump to content

Has anyone actually printed the LED Printed Clock from the KH-327 show notes and assembled it?

G+_Hyrum Smith

By G+_Hyrum Smith,
in Know How

 Share

Recommended Posts

G+_Hyrum Smith Newbie

G+_Hyrum Smith

Posted
Posted

Has anyone actually printed the LED Printed Clock from the KH-327 show notes and assembled it? Did you notice anything was missing or different than was shown on the assembly episodes? Did you just create the missing / incorrect parts yourselves? Just checking to see what I have to do to finish this project.

Thanks!

Link to comment
Share on other sites
G+_Hyrum Smith Newbie

G+_Hyrum Smith

Posted
  • Author
Posted

Eric Boyle? The missing parts are: Left & right post caps, & the covers for the base wire tray - left & right.

 

A difference between the assembly show and Then he print files is with the ring mounts. The ring was provided in two flavors - one with the mounting posts attached, and another file with a hole in the ring for separate mount pins (the pins were also provided separately). The assembly show had wires coming out of the ends of the ring mounts. There are no holes in either configuration of the ring mount. That's not a big deal since I own a drill but was that the design intent rather than printing the part with the holes, or we're just the wrong files included in the zip file.

Link to comment
Share on other sites
G+_Hyrum Smith Newbie

G+_Hyrum Smith

Posted
  • Author
Posted

Eric Boyle? Well, I have no other folders in the Support Files folder. I just downloaded the zip from Dropbox again and it is the same as what I had. The zip file is 779 KB that is currently available on the Dropbox link in the show notes. If you would email them to me, that would be great, THANKS!

Link to comment
Share on other sites
 Share
Go to topic listing
×
×
  • Create New...