G+_Oliver Jackson Posted August 26, 2015 Share Posted August 26, 2015 Rotor has come off, how would I go about fixing it? do I need some sort of glue to attach the shaft to the rotor? Something like loctite worth a try? Link to comment Share on other sites More sharing options...
G+_Taylor Graham Posted August 26, 2015 Share Posted August 26, 2015 Thats called a bell housing. Depending on your motor, its probably connected with a circlip, but some are held down with the retaining nut/screw on the top. You'll just need to push it back on and reattach whatever was holding it down. Link to comment Share on other sites More sharing options...
G+_Oliver Jackson Posted August 26, 2015 Author Share Posted August 26, 2015 Taylor Graham there was nothing holding it in, I think it must have been held in by tight manufacturering tolerances. Link to comment Share on other sites More sharing options...
G+_Oliver Jackson Posted August 26, 2015 Author Share Posted August 26, 2015 Wayne Hobbins? I'll upload a video, they are rtfq 1806 2300kv motors, I can attach them just wondering if the little force I need to pull them off with is an issue whilst flying. ?7 minutes or so. Link to comment Share on other sites More sharing options...
G+_Oliver Jackson Posted August 26, 2015 Author Share Posted August 26, 2015 Wayne Hobbins oh right cheers, it was really hard to see the screw it's tiny. Thanks again! ? Link to comment Share on other sites More sharing options...
G+_Oliver Jackson Posted August 30, 2015 Author Share Posted August 30, 2015 James T 0.9mm hex went to my local engineering store and it fit perfectly. Link to comment Share on other sites More sharing options...
G+_Oliver Jackson Posted August 30, 2015 Author Share Posted August 30, 2015 James T Just a hardware store tbh... They are just call harrisons engineering, but as I said 0.9 mm. Link to comment Share on other sites More sharing options...
Recommended Posts